Computer Organization
Q131.
A device employing INTR line for device interrupt puts the CALL instruction on the data bus whileQ134.
Which one of the following is true for a CPU having a single interrupt request line and a single interrupt grant line?Q137.
A 4 kilobyte (KB) byte-addressable memory is realized using four 1 KB memory blocks. Two input address lines (IA4 and IA3) are connected to the chip select (CS) port of these memory blocks through a decoder as shown in the figure. The remaining ten input address lines from IA11-IA0 are connected to the address port of these blocks. The chip select (CS) is active high. The input memory addresses (IA11-IA0), in decimal, for the starting locations (Addr=0) of each block (indicated as X1, X2, X3, X4 in the figure) are among the options given below. Which one of the following options is CORRECT?Q138.
The chip select logic for a certain DRAM chip in a memory system design is shown below. Assume that the memory system has 16 address lines denoted by A_{15} \; to \; A_0. What is the range of address (in hexadecimal) of the memory system that can get enabled by the chip select (CS) signal?Q139.
A 32-bit wide main memory unit with a capacity of 1 GB is built using 256M x 4-bit DRAM chips. The number of rows of memory cells in the DRAM chip is 2^{14}. The time taken to perform one refresh operation is 50 nanoseconds. The refresh period is 2 milliseconds. The percentage (rounded to the closest integer) of the time available for performing the memory read/write operations in the main memory unit is __________.